65 83 565 Removing and installing/replacing front trim for Car Communication Computer (holder)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

12 7 192

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) , see 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
Risk of damage!
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and earth/ground.

Necessary preliminary tasks:

Remove front trim for Car Communication Computer , see 65 83 560 Removing and installing/replacing front trim for Car Communication Computer .

Release screws (1) and remove holder (2).

Installation:

Retaining pin (1) must be adapted to fit in guide hole (2).

Fig 1: Identifying Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Identifying Pin And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guide tabs (1) must be correctly inserted in front trim holder.

Fig 3: Identifying Guide Tabs In Front Trim Holder

Courtesy of BMW OF NORTH AMERICA, INC.