51 16... Removing and installing/replacing cup holder in rear console

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear seats , see 52 26 000 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT REAR SEAT .

Release screws (1) under rubber insert.

Release screws (2 and 3) on left and right sides.

Disconnect plug connection (4).

Lift out center console (5).

Fig 1: Identifying Centre Console, Plug Connection And Screw

G06212474

Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Feed cup holder from below out of frame (2) in direction of arrow first at point A, then at point B.

Fig 2: Identifying Frame And Screws

G06212484

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1) on cup holder (2) must not be damaged.

Make sure guides (1) are correctly engaged.

Fig 3: Identifying Guides And Cup Holder

G06212476

Courtesy of BMW OF NORTH AMERICA, INC.