LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2114 (Body Equipment - Repair) >> Front And Rear Window >> 51 31 021 Removing and installing/replacing rubber frame for windscreen (top) >> Replacement of rubber frame with removed or new windscreen

Replacement of rubber frame with removed or new windscreen

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

There is no tear-off lip (3) and no butyl tape (4) in area (A).

Install rubber frame (1) with tear-off lip (3), paying attention to center marking in so doing.

After installing windscreen: If necessary, pull liner* off adhesive tape (5) and press rubber frame (1) down firmly on roof outer skin.

2 Aluminium strip

4 Butyl tape

6 Adhesive tape (for bonding on roof, top)

* Liner is the protective film on adhesive tape (6).

Fig 1: Identifying Tear-Off Lip, Rubber Frame, Adhesive Tape And Windscreen
G04788676Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals