41 34 060 Replacing Outer And Inner Tail Panel Sections Stripping-Down Operations

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Remove battery
Remove battery negative cable
Remove bumper trim
Remove bumper carrier
Remove center guide
Remove luggage compartment floor trim panel
Remove lashing rail in luggage compartment on left and right
Remove luggage compartment storage compartment
Upper tail panel trim
Remove rear lid lock
Remove left luggage compartment wheel arch panel
Remove right luggage compartment wheel arch panel
Partially detach rear lid seal

Slacken nut (1).

Remove earth support point.

Unclip wiring harness (2) from retainers and lay towards front.

Fig 1: Identifying Wiring Harness And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Remove earth support point.

Unclip wiring harness (2) from tail panel and lay towards front.

Release nuts (3) and lay control unit (4) towards front.

Fig 2: Identifying Cable, Connector, Bumper Carrier And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and screws (2).

Lay distribution box (3) towards front.

Fig 3: Identifying Distribution Box, Nuts, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.