41 5.... Removing And Installing Door

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Front door:

Tightening torque 41 51 4AZ , see 41 51 FRONT DOORS .

Rear door:

Tightening torque 41 52 4AZ , see 41 52 REAR SIDE DOORS .

Fig 1: Locating Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Front door:

Tightening torque 51 21 3AZ , see 51 21 FRONT DOOR LOCKS HANDLES ..

Open door up to stop.

Fig 2: Identifying Door Retainer Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts between both hinge elements at top and bottom.

Front door:

Tightening torque 41 51 1AZ , see 41 51 FRONT DOORS .

Rear door:

Tightening torque 41 52 1AZ , see 41 52 REAR SIDE DOORS .

Fig 3: Identifying Hinge Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Unhinge door by moving upwards and placing it on a suitable surface.

Installation:

If necessary, adjust door.

Fig 4: Adjusting Door

Courtesy of BMW OF NORTH AMERICA, INC.