34 00 050 Bleeding brake system with DSC: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove left microfilter housing cover . See 64 31 101 REMOVING AND INSTALLING/REPLACING LEFT MICROFILTER HOUSING COVER .
- Read and comply with General Information .
IMPORTANT:
When replacing or repairing, observe the filling and bleeding instructions for the following parts:
Connect bleeder unit with max. 2 bar filling pressure.
A second person is needed to help carry out this work.
- Tandem brake master cylinder
- Hydraulic unit
- Components and connecting lines which are fitted between these assemblies.
Connect bleeder unit with max. 2 bar filling pressure.
A second person is needed to help carry out this work.
Connect DIS.
Select path: Service functions - Chassis/Suspension - Slip control systems - Bleeding procedure.
IMPORTANT:
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.
Charging pressure should not exceed 2 bar.
Connect brake fluid changer to expansion tank and switch on.