33 32 051 Removing and installing/replacing left or right push rod/integral link: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the integral link is detached from the wheel carrier or swinging arm, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
- Remove REAR WHEEL .
- Tension COIL SPRING (and leave on vehicle)
- Version with ride-height control: Deactivate and drain AIR SPRING system
Release nut (1) and remove screw.
Release screw (2) and remove integral link (3).
Installation:
Replace self-locking nut.
First install swinging arm hand-tight, then tighten down screw (2).
Tighten screw/bolt connections in NORMAL POSITION .
Tightening torque (nut) 33 32 3AZ .
Tightening torque (bolt) 33 32 4AZ .