32 21 151 Replacing left or right track rod end: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
NOTE:
If the tie rod end to tie rod screw/bolt connection is released, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
- Remove FRONT WHEEL
IMPORTANT:
Do not
release tie rod end from swivel bearing with impact tool.
Make sure special tool rests correctly on steel bushing of swivel bearing. The swivel bearing must be removed if the steel bushing moves.
Rubber gaiter of tie rod end must not be damaged!
Do not pull stainless steel ring off journal.
Make sure special tool rests correctly on steel bushing of swivel bearing. The swivel bearing must be removed if the steel bushing moves.
Rubber gaiter of tie rod end must not be damaged!
Do not pull stainless steel ring off journal.
Slacken nut (1) two to three thread turns.
If necessary, replace lower section 31 2 242 with lower section 31 2 246 .
Press tie rod end (2) with special tool 31 2 240 off swivel bearing.
Unscrew nut (1) and remove tie rod end (2) from swivel bearing.
Installation:
Keep tie rod end to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
Tightening torque 32 21 3AZ .
Determine measurement (A) to simplify following adjustment of front axle.
Slacken nut.
Unscrew tie rod end from tie rod.
Installation:
Check GAITER for damage, replace if necessary.
Refit clamping ring (1).
Screw tie rod end onto tie rod to measurement (A).
Tightening torque 32 21 2AZ .