32 41 311 Replacing suction line for power steering (N63)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove FRONT UNDERBODY PROTECTION
- Remove OIL RESERVOIR
Unlock suction line (1) on hydraulic reservoir (2) and detach in direction of arrow.
Expose suction line up to connection on vane pump.
Unfasten hose clip (2).
Detach suction line (1) from vane pump.
Installation:
Replace hose clamp (1).
Identification (P) of suction line and rib (3) on vane pump connections serve as an approximate guide to alignment.
Make sure hydraulic line is laid without tension and with sufficient spacing to adjoining components.
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check pipe connections for leaks