32 41 033 Removing and installing/replacing power steering pump for hydraulic steering box with active steering (N55): Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with plugs.
Seal off hydraulic lines with plugs.
IMPORTANT:
Aluminium screws/bolts must be replaced each time they are released.
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove FRONT UNDERBODY PROTECTION
- Remove COVER OF STEERING ASSEMBLY at bottom left
- Remove fan cowl with electric fan
- Remove BELT PULLEY
Release hose clamp (1) and detach suction line from power steering pump.
Installation note:
Replace hose clamp.
Make sure hydraulic lines are laid without tension and with sufficient distance to adjoining components.
Align intake pipe by way of marking (2) to power steering pump connection marking.
Release screw (1).
Tightening torque 32 41 6AZ .
Detach pressure line (2).
Installation note:
Replace sealing ring.
NOTE:
Figure shows N52
Unfasten plug connection (1) and disconnect.
Unscrew screws (2) and (5).
Tightening torque 32 41 9AZ .
Installation note:
Replace aluminium screws.
Observe SCREWING SEQUENCE !
Release screws (1).
Tightening torque 32 41 9AZ .
Installation note:
Replace aluminium screws.
Observe SCREWING SEQUENCE !