24 00 050 Installing exchange transmission (GA6HP19Z) (X6 35i)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ .
IMPORTANT:
After completion of work, program transmission control unit.
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
IMPORTANT:
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
- Before installing replacement transmission, always flush transmission fluid cooler together with lines . See 17 21 500 FLUSHING TRANSMISSION OIL COOLER WITH LINES (AUTOMATIC TRANSMISSION) (GA6HP19Z, GAHP26Z, GA6HP32Z) .
- After completion of work, check transmission fluid level. See 00 11 500 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6HP19Z)
.
Replacement transmission is supplied filled with transmission fluid.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove automatic transmission. See REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA6HP19Z) .
Convert selector lever (1).
Tightening torque 24 51 1AZ .
Modify holder (2).
Modify transfer box.
Convert transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Convert protective cap on output shaft.
IMPORTANT:
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Service.
- On type plate