24 40 010 Removing and installing/replacing torque converter (GA6HP26Z) (X6 50i)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 2 550

IMPORTANT: After completion of work, check TRANSMISSION FLUID LEVEL .
Use only approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

Remove AUTOMATIC TRANSMISSION .

Pull torque converter (1) by hand out of housing and set down vertically.

NOTE: When torque converter is removed, transmission oil flows out.

Fig 1: Identifying Torque Converter

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

When installing, do not damage shaft seal and bearing.

If the torque converter is not correctly installed, the driver of the pump impeller may be damaged when the transmission is flanged to the engine.

Installation note:

Push torque converter through shaft seal onto transmission shaft as far as it will go.

Press torque converter by hand into converter housing and turn in the process. Converter hub opening must snap into place in driver of pump impeller. Torque converter must be felt to slip inwards.

Calculate measurement between contact face and top edge of converter (1) with special tool 00 2 550 (depth gauge).

NOTE: Measured value must be min. 25 mm.

Fig 2: Calculating Measurement Between Contact Face And Top Edge Of Converter Using Special Tool (00 2 550)

Courtesy of BMW OF NORTH AMERICA, INC.