86 21... Adjusting hood pretension - Camloc fastener with spacers: Installation

Before attaching the hood, thoroughly clean the top side of the GFP apron of the BMW multitrailer.

It is particularly important to clean the contact surface of the GFP apron (1) (marked in gray) on which the rubber seal of the hood rests. Refer to Fig 1.

Fig 1: Identifying GFP Apron (Marked In Gray)

Courtesy of BMW OF NORTH AMERICA, INC.

The following text describes how to adjust the hood pretension as an example at one support area of the platform or at one hood fastener. The pretension is adjusted at the other support areas and fasteners in the same sequence.

The hood must be fixed on the platform in such a way that the rubber seal of the hood is placed under pretension or compressed. Only with this pretension is it possible to obtain a tight seal between hood and platform. Pretension is achieved with the Camloc fasteners and by using spacers.

Two different types of spacers (2) are available for each Camloc fastener (1): one thick and one thin. You can fit one, two or no spacer (2) on the Camloc fastener (1).

Fig 2: Identifying Spacer On Camloc Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Access to hood lighting plug (1):

Right side lid.

Open out spring-loaded cap (2) on socket (3) and remove hood lighting plug (1). Close cap (2). Insert hood lighting plug (1) into plug receptacle (4).

Fig 3: Inserting Hood Lighting Plug Into Plug Receptacle

Courtesy of BMW OF NORTH AMERICA, INC.

Unlocking Camloc fastener:

Wing (1) of Camloc fastener (2) is parallel to outer edge of hood. Turn Camloc fastener (2) counterclockwise until it is heard and felt to unlock.

Use new spring nut.

Remove Camloc fastener (1) from locating hole (2).

Press Camloc fastener (1) downwards until contact is made with hood stop. Wing (3) of Camloc fastener points to middle of hood.

Fig 1: Press Camloc Fastener Downward Until Contact Is Made

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing spacer:

Remove spacer (1) from Camloc fastener (4) by aligning opening (2) over lateral pin (3).

Fig 2: Identifying Spacer, Camloc Fastener And Lateral Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Reducing pretension:

Reduce spacer thickness, replace spacer or install Camloc fastener without spacer.

Increasing pretension:

Fit a thicker spacer or two spacers.

Place spacer (1) on Camloc fastener (4) and turn until it is in a secure position.

Check that hood seal is correctly seated.

Check that Camloc fasteners are locked. Lift hood by handle recesses. Hood must not be able to move with respect to platform of BMW multitrailer.