22 32 001 Replacing Rubber Mount For Transmission Mounting (ATC 700): Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

For the following special tools, refer to ENGINE AND GEARBOX SUSPENSION - SPECIAL TOOLS (N54, N63) .

22 1 016
22 1 017
22 1 101
22 1 102
22 1 103

For the following special tools, refer to REAR AXLE - SPECIAL TOOLS .

33 4 465

Necessary preliminary tasks:

Remove crossmember for transmission mounting. See 22 32 050 REPLACING CROSSMEMBER FOR TRANSMISSION MOUNTING .

Place special tool 22 1 016 on opening (1) and insert screw (2) until hand-tight against housing.

Pull out rubber mount with special tools 22 1 101/33 4 465 and nut (22 1 017).

Fig 1: Pulling Rubber Mount With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.