17...... Venting cooling system for intercooler (N63): Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 2 030
See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
WARNING:
Danger of scalding!
Open sealing cap only after engine has cooled down.
Open sealing cap only after engine has cooled down.
IMPORTANT:
Cooling system for intercooler has a separate cooling circuit.
Coolant is added at intercooler expansion tank.
Electric coolant pump!
Follow instructions for working on cooling system .
Coolant is added at intercooler expansion tank.
Electric coolant pump!
Follow instructions for working on cooling system .
IMPORTANT:
Lifetime coolant filling:
Never reuse used coolant!
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of partial quantities of coolant, replace these quantities which have been drained with new coolant.
Never reuse used coolant!
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of partial quantities of coolant, replace these quantities which have been drained with new coolant.
IMPORTANT:
Risk of slipping due to coolant on the floor.
Danger of injury!
Danger of injury!
Catch and dispose of drained coolant in drip tray (1) and if necessary special tool 00 2 030 (universal hydraulic lifter).
Recycling:
Observe country-specific waste-disposal regulations.
IMPORTANT:
The following venting procedure is necessary when a part is replaced in the cooling system or when the cooling system is refilled.