13 53 208 Removing And Installing/Replacing Right Rail (N63): Recycling

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Fuel escapes when fuel line is detached. Catch and dispose of escaping fuel.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks:

Read out fault memory of DME control unit. If necessary, work through test schedules.
Switch off ignition.
Remove fuel feed line .
Disconnect all pressure lines on right.
Remove front right WHEEL ARCH COVER (FRONT SECTION) .

Unlock plug (1) on high-pressure sensor and disconnect.

Release screws (2).

Tightening torque, see 13 53 1AZ in 13 53 FUEL INJECTION NOZZLES AND PIPES .

Remove rail (3).

Fig 1: Identifying Unlock Plug & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Assemble engine. Check fuel system for leaks. Now clear the fault memory.