12 41 041 Replacing solenoid switch

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Turn off ignition.

Remove starter motor.

Release nut (1).

Remove cable lug (2).

Fig 1: Identifying Starter Motor Nut And Cable Lug

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not turn cable lug (2) while tightening down - risk of short circuit to starter motor housing.
Tightening torque, 12 41 4AZ , see 12 41 STARTER MOTOR WITH MOUNTING .

Release screws (1).

Fig 2: Identifying Cable Lug And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove solenoid switch (1) and spring (2).

Unhook pin (3).

Installation:

Check pin (3) for wear and apply grease.

Fig 3: Identifying Solenoid Switch, Spring And Unhook Pin

Courtesy of BMW OF NORTH AMERICA, INC.