11 14 250 Removing and installing/sealing rear coolant end cover (N63)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 11 4 470
See ENGINE - SPECIAL TOOLS (N54, N63) .
WARNING:
Danger of scalding!
Only perform this work after engine has cooled down.
Recycling:
Catch and dispose of drained coolant in a suitable container.
Observe country-specific waste-disposal regulations.
Necessary preliminary tasks:
- Remove flywheel
- Drain coolant . See 17 00 008 DRAINING AND ADDING COOLANT IN RADIATOR (N62TU, N63) .
Release all screws in area (1).
Tightening torque 11 14 5AZ, see 11 14 CASE COVERS
Remove end cover.
NOTE:
Clean sealing faces with special tool 11 4 470.
Installation:
Replace profile seal (1) .
Assemble engine.