64 11 866 Removing and Installing/Replacing Servodrive For Blending Flap (Left)
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove trim panel for pedal assembly. Refer to PANEL FOR PEDALS (Coupe) or PANEL FOR PEDALS (Convertible).
NOTE:
For purposes of clarity, the following graphics show the heater/air conditioner removed.
Disconnect plug connection (1).
Release screws (2).
Remove servodrive at side.
Installation:
Do not twist teeth of servodrive.