64 11 829 Replacing Servodrive For Ventilation Flaps
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove right glovebox with housing. Refer to RIGHT GLOVEBOX WITH HOUSING (Coupe) or RIGHT GLOVEBOX WITH HOUSING (Convertible).
Unfasten plug connection (1) and disconnect.
Release screws (2).
Detach servodrive for ventilation flaps (3) in direction of arrow from heater/air conditioner (4).
Installation:
Place servodrive for ventilation flaps (3) over guide pin (5).