51 61... Removing And Installing/Replacing Front Rollover Protection System Strut
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
Driving without the strut is not permitted!
Necessary preliminary tasks:
- Remove rear seat back . See SEATS - REPAIR (CONVERTIBLE) .
Release screws (1).
Tightening torque, see 51 71 27AZ in 51 71 SEALS AND LOOSE BODY PARTS .
Release screws (2) and remove strut (3).
Tightening torque, see 51 71 28AZ in 51 71 SEALS AND LOOSE BODY PARTS .
Installation:
Replace all screws.