51 12 156 Removing And Installing/Replacing Rear Bumper Trim (M Technic Aerodynamic Kit): Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both rear lights . See LIGHTS - REPAIR (128i) or LIGHTS - REPAIR (135i) .

NOTE: Description is shown on the E82 by way of example. There may be differences in detail in the case of other models.

Prior to removing, pay attention to the exact installation position with respect to the adjoining components.

Release screws (1) on wheel arch trim (2) on left/right.

Installation:

Make sure wheel arch trim (2) is in correct position.

Fig 1: Identifying Wheel Arch Trim Screws

G05779032

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows E92. Screw (1) not fitted on E82/E88.

Bend wheel arch cover (2) in area (A) to one side and release screw (3) on left/right.

Fig 2: Identifying Area Of Bending Wheel Arch Cover

G04752461

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 3: Identifying Screws On Bumper Trim

G05779034

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Risk of damage!

Do not detach bumper trim (1) at sides

The following work must be carried out with a second person assisting:

NOTE: Picture shows E92.

Pull bumper trim (1) towards rear and release from catches (2).

Fig 4: Releasing Bumper Trim From Catches

G04752463

Courtesy of BMW OF NORTH AMERICA, INC.

Press down catch (2).

Remove bumper trim (1) towards rear with aid of a 2nd person.

If necessary, disconnect plug connection on ultrasonic transducers.

Fig 5: Identifying Bumper Trim & Catch

G04752464

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and guides (2) must not be damaged.

If necessary, replace faulty sheet nuts (3) on left/right.