51 16... Removing And Installing/Replacing Mounting For Cup Holder At Front

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove storage compartment

Release screws (1).

Remove holder (2) and trim (3).

Installation:

Spring (4) on holder (2) must not be damaged or missing.

Fig 1: Identifying Screws With Holder & Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts must not be damaged or missing:

Screw mountings
Spring
Trim

Fig 2: Identifying Screw Mountings With Spring & Trim
Courtesy of BMW OF NORTH AMERICA, INC.