51 23 160 Removing And Installing/Replacing Arrester Hook On Engine Hood

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Raise bonnet/hood lid.

Release screws (1) and remove arrester hook (2).

Tightening torque, see 51 23 1AZ in 51 23 HOOD/BONNET LOCKS .

Fig 1: Identifying Screws & Arrester Hook

Courtesy of BMW OF NORTH AMERICA, INC.