51 41 019 Removing And Installing Or Replacing Door Handle On Door Trim Panel, Front Left Or Right: Replacement

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Saw off welding pins (1) on door handle (2) down to measurement (A).

A= 2.0 ± 0.5 mm

Fig 1: Identifying Measurement A

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Door handle:

position in door trim panel (1)
secure at top, middle and bottom with repair screws (2)
align until bore (3) is centrally located
tighten down, starting in middle

Tightening torque, see 51 41 3AZ in 51 41 FRONT DOOR TRIM PANEL WITH ARMRESTS .

NOTE: If bores have not been correctly drilled through, increase tightening torque according in order to ensure that door handle is firmly seated.

Fig 2: Identifying Door Trim Panel With Screws

Courtesy of BMW OF NORTH AMERICA, INC.