LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2042 (Body Equipment - Repair (E88)) >> Front Bumper >> 51 11... Installing/Replacing Number/License Plate (Without Base) >> Initial Fitting

Initial Fitting

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to number/license plate.

Remove template (1) and secure number/license plate with screws provided.

Tightening torque, see 51 11 3AZ in 51 11 FRONT BUMPER .

Fit protective caps.

Fig 1: Identifying Drilling Hole Template On Bumper
G04752434Courtesy of BMW OF NORTH AMERICA, INC.

Place drilling hole template (1) on radiator grille (2) and bumper (3).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to number/license plate.

Remove template (1) and secure number/license plate with screws provided.

Tightening torque, see 51 11 3AZ in 51 11 FRONT BUMPER .

Fit protective caps.

Fig 2: Identifying Drilling Hole Template On Radiator Grille & Bumper
G04752435Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals