51 11 055 Removing And Installing/Replacing Support For Front Bottom Bumper Panel
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front Bumper Trim or Front Bumper Trim (M Technic Aerodynamic Kit) .
Remove impact absorber (1). Mark top side on support (3). Release screws (2) and remove support (3). Tightening torque 51 11 5AZ.
Installation note : Install support (3) with marked side towards top.