Starting Removal
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Spool can only be turned in one direction.
- Make sure the wire is always situated in the guide channel of the suction cup lifter (1)
- Fit reversible ratchet on spool (2) and tension wire
- Start by cutting lower adhesive bead
- Both wires meet ahead of both spools when removal is completed
- Remove "Roll Out 2000"
- Remove disc