Preparation For Assembly: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Prepare plastic nozzle(s) for shaping adhesive bead (when not using the standard nozzle), can be cut to size during the air drying time.
Lay a test bead of approx. 50 mm - watch out for formation of bubbles/blisters when hot cementing; if OK, apply immediately to window glass.
- Interruption must be < 5 second (incorrect mixture ratio).
Cartridge must be vertical to window glass.
Black ceramic material impermeable to UV light is located on the peripheral zone of the inside edge of the window to protect the adhesive bead.
Glass ceramic material must not be damaged and must be treated as follows.