LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2042 (Body Equipment - Repair (E88)) >> Floor/Luggage/Engine Compartment Panel >> 51 47 151 Removing And Installing/Replacing Left Luggage Compartment Wheel Arch Trim

51 47 151 Removing And Installing/Replacing Left Luggage Compartment Wheel Arch Trim

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

Release convertible top compartment spring (1) at bottom.

Release expander rivets (2 and 3).

Partially raise partition wall panel (4) and rear window frame panel (5) in covered area.

Remove rear light cover (6).

Installation: 

If necessary, replace faulty expander rivets (2 and 3).

Fig 1: Releasing Expander Rivets
G06176945Courtesy of BMW OF NORTH AMERICA, INC.

Unclip emergency release knob (1) in direction of arrow.

Detach Bowden cable (2) from emergency release knob (1).

Release expander rivets (4).

Feed out panel (5) and remove.

Installation: 

Catches (3) on emergency release knob (1) must not be damaged.

If necessary, replace faulty expander rivets (4).

Fig 2: Uncliping Emergency Release Knob
G06176946Courtesy of BMW OF NORTH AMERICA, INC.