51 14 000 Removing And Installing/Replacing Front BMW Badge
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
IMPORTANT:
Risk of damage!
To avoid damaging the paintwork on the engine hood/bonnet, tape off edge areas (1) to sides of guide pins.
So as not to subject the BMW badge to excessive deformation, lever out the badge with special tool 00 9 318 at guide pins (2).
Installation:
Following parts must not be damaged or missing:
- Badge
- Guide pins
- Grommets