37 14 512 Replacing Rear Ride-Height Sensor

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

NOTE: Tightening torque 37 14 3AZ .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque 37 14 3AZ .

Fig 1: Identifying Nut, Jointed Rod, Plug Connection & Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (3).

Release bolt (4) and remove ride-height sensor with bracket.

Installation:

Align bracket to corresponding bore hole (arrow) in rear axle carrier.

Tightening torque 37 14 2AZ .

Replacement:

Release screws (1) and remove ride-height sensor from bracket (2).

Installation:

Sensor lever (3) must point from ride-height sensor in direction of screw fastening point (arrow) of bracket.

Tightening torque 37 14 1AZ .

Fig 2: Identifying Sensor Lever Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check headlight adjustment, correct if necessary. Refer to ADJUSTING HEADLIGHTS .