37 14 511 Replacing Front Ride-Height Sensor

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque 37 14 3AZ .

Release screws (4).

Remove ride-height sensor and disconnect plug connection (3).

Fig 1: Identifying Nut, Jointed Rod, Plug Connection & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Sensor lever (5) must point from ride-height sensor to left front wheel.

Tightening torque 37 14 1AZ .

After installation:

Check headlight adjustment, correct if necessary. Refer to ADJUSTING HEADLIGHTS .