41 11 734 Replacing Complete Rear Tension Strut Mounting
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Read contents of Body, General . Refer to 41 0 Contents Of Body, General .
Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.
Following new body parts are required:
Open weld joints in areas (1).
Open weld joints in areas (2) on both sides of rear axle carrier (3).
Installation information:
To adjust new part to fit, screw down tension strut.
If vehicle is on straightening bench, adjust new part to fit with straightening attachment or universal mount.