LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2039 (Wheel And Tires - Repair) >> Disc Wheels (Rims) >> 36 11 533 Removing and installing/replacing a tire pressure control electronic wheel module (Generation I) >> Removing electronic wheel module

Removing electronic wheel module

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

Release union nut with special tool 00 2 190; if necessary, grip valve insert (1) at cylindrical section of ball head.

Remove valve insert from rim.

Fig 1: Release Union Nut Using Special Tool (00 2 190)
G06890139Courtesy of BMW OF NORTH AMERICA, INC.

Remove washer (1).

Fig 2: Identifying Washer
G06890140Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Before the installation of new wheel electronics with valve, thoroughly clean the valve bore of the wheel rim!
Also make sure that the valve bore is free of burrs
scientia non olet · About LEMON Manuals