36 11 121 Removing and installing/replacing an RDC trigger transmitter (front)
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Partially detach front WHEEL ARCH TRIM .
Press through studs (1) of expander rivets towards rear.
Remove trigger transmitter (2).
Installation:
If necessary, replace expander rivets.
After installation:
- Carry out RESETTING OF RDC .