34 00 025 Replacing fluid in ABS/ASC+T brake system: Notes

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Read and comply with General Information .

IMPORTANT: When carrying out repairs to the brake system, follow the procedure set out in Bleeding brake system with DSC .

Unclip retaining tabs (1).

Pull cover (3) out of guide (2) and remove.

Fig 1: Identifying Retaining Tabs, Cover And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Connect brake fluid changer to expansion tank and switch on.

NOTE: Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.

Fig 2: Connecting Brake Fluid Changer To Expansion Tank

Courtesy of BMW OF NORTH AMERICA, INC.