32 41 250 Removing and installing/replacing fluid reservoir for power steering
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
Release screw (1).
Tightening torque 32 41 1AZ .
NOTE:
If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.
Remove hose clamps if necessary with special tool 32 1 260 .
Disconnect suction line and radiator return line from fluid reservoir.
Lift out fluid reservoir.
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check pipe connections for leaks