00..... Raising vehicle with trolley jack

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe the following trolley-jack-related instructions:

Use only BMW-distributed/approved trolley jacks which have rubber plate contact points.
Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
Check the rubber plate on the trolley jack prior to each use, replacing if necessary.

Fig 1: Identifying Trolley Jack
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: All-wheel drive vehicles may only be raised with the stiffening plate mounted on the front axle (1)!
Raising directly on the front axle support without stiffening plate is not permissible!

WARNING: The vehicle may be raised with a trolley jack only at the following jacking points!

Car jacking point
Side car jacking points
Rear axle final drive
NOTE: It is not permitted to raise the vehicle at the rear differential cover!

Fig 2: Identifying Car Jacking Point, Side Car Jacking Points And Rear Differential

Courtesy of BMW OF NORTH AMERICA, INC.

Risk of damage!

Jacking point (1) must be present!

Align the rubber plate on the trolley jack to the jacking point (1) in such a way that there is no contact to adjacent components and that they are therefore not damaged.

Fig 3: Identifying Jacking Point

Courtesy of BMW OF NORTH AMERICA, INC.