M57T2 only

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1).

NOTE: Illustration similar.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove exhaust system bracket.

Tightening torque 24 71 6AZ .

Fig 1: Identifying Exhaust System Bracket Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) by turning.

Fig 2: Disconnecting Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 3: Inserting Special Tool In Sealing Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock sealing sleeve with slide (1).

Fig 4: Identifying Sealing Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!

Fig 5: Pulling Out Sealing Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.