23 14 550 Removing/Replacing Zero Gear Sensor
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After installing the zero gear sensor, it is necessary to teach in the position of the zero gear sensor again.
Adjustment is carried out with the "Service function" of the DIS Tester (learn/write zero gear sensor).
Adjustment is carried out with the "Service function" of the DIS Tester (learn/write zero gear sensor).
Necessary preliminary tasks:
- Lower transmission
Tasks are described in Removing transmission. See REMOVING AND INSTALLING TRANSMISSION (GS6-53BZ) N54 .
Disconnect plug connection (1) on zero gear sensor.
Release screws (2).
Remove zero gear sensor.
Tightening torque 23 14 2AZ .