22 11 001 Replacing Right Engine Mount (N54)

Necessary preliminary tasks: 

• Secure engine in INSTALLATION POSITION .
• Remove underbody protection
• Release tie rod on steering gear. See REPLACING (REMOVING AND INSTALLING) LEFT OR RIGHT TIE ROD .
• Remove right V-strut (E93 only).

Release bolts (1).

Remove heat shield (2).

Fig 1: Identifying Bolts And Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1) and remove engine mount towards front.

Tightening torque 22 11 1AZ .

Fig 2: Identifying Engine Mount Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Make sure rubber (1) is correctly located.

Fig 3: Identifying Rubber

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Rubber section (1) of engine mount must point to middle of vehicle.

Engine mount designations:

Right engine mount

• Even component number

Left engine mount

• Odd component number
  Fig 4: Identifying Rubber Section Of Engine Mount

  Courtesy of BMW OF NORTH AMERICA, INC.