11 00 Removing And Installing/Replacing Ignition Coil Cover (N54)
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove microfilter housing . See 64 31 092 REMOVING AND INSTALLING/REPLACING MICROFILTER HOUSING (LOWER SECTION) .
Release screws.
Tightening torque. See 11 12 7AZ in CYLINDER HEAD WITH COVER .
Remove ignition coil cover (1) towards top.
NOTE:
For purposes of improved clarity, illustration and descriptions shows wiring harness and tension strut removed.