61 71 015 Removing And Installing/Replacing A Spray Nozzle In Windscreen Washer System

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The jet nozzles of the windscreen washer system are preset at the factory and cannot be readjusted.

Disconnect plug connection (1).

Detach hose (2) from spray nozzle (4).

Press in retaining lug (3) in direction of arrow and feed out spray nozzle (4) through opening.

Installation:

Make sure spray nozzle (4) is correctly seated
Ensure hose is laid without kinks.

Fig 1: Pressing Retaining Lug
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of spray nozzle (4) must not be damaged or missing:

(1) Plug connection
(2) Hose connection
(3) Detent lug, bottom
(5) Detent lug, top

Fig 2: Identifying Plug Connection & Hose Connection With Spray Nozzle
Courtesy of BMW OF NORTH AMERICA, INC.