00 00... Tires: Checking Inflation Pressure, Correcting If Necessary (Incl. Spare Wheel), Checking External Condition, Tread Depth, Pattern

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

Checking tire inflation pressure:
- Check tire inflation pressure in accordance with information plate on B-pillar
- The inflation pressure in the spare wheel must be 0.5 bar higher than the maximum specified value on the information plate
- Initialize 36 11 000 INITIALIZING RUN FLAT INDICATOR (RPA) Run Flat Indicator .
Checking tire condition:
- Check tread depth of all tires with tire tread gauge
- Check tire tread surfaces and side walls for incisions and foreign particles such as nails or screws
- Check tire tread pattern for localized flattening and wear on one side; if necessary, carry out wheel/chassis alignment after consulting with customer and issue a separate invoice for this work

NOTE:

For reasons of driving safety, only use tires of the same type and tread pattern on a single vehicle
Inform customer of any incorrect or worn tires