65 24 020 Removing and Installing/Replacing Left Or Right Blocking Circuit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove panel for roof pillar at rear . Refer to 51 43 251 REMOVING AND INSTALLING OR REPLACING TRIM PANEL FOR LEFT OR RIGHT REAR ROOF PILLAR (C-PILLAR) (Coupe) only.

Disconnect plug connection (1).

Unfasten screw (2) and remove blocking circuit.

Fig 1: Identifying Plug Connection & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit blocking circuit (1) so that screw (2) engages thread (3) and locating pin (4) engages bore (5).

Fig 2: Identifying Blocking Circuit, Screw, Thread & Locating Pin

Courtesy of BMW OF NORTH AMERICA, INC.