65 75 071 Removing And Installing (Replacing) Module For Passenger Compartment Sensor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) (Coupe).

Necessary preliminary tasks:

Remove complete ceiling light (rear) . Refer to 63 31 004 REMOVING AND INSTALLING OR REPLACING COMPLETE CEILING LIGHT (REAR, WITH MODULE FOR PASSENGER COMPARTMENT PROTECTION) .

Open retaining shook (1) in direction of arrow and remove module for passenger compartment sensor (2) from trim (3).

Installation:

Retaining hooks (1) must not be damaged.

Arrow (4) must point in opposite direction to direction of travel.

Fig 1: Identifying Retaining Shook, Passenger Compartment Sensor And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding for BMW/MINI service functions in Progman.