52 26 311 Removing And Installing/Replacing Lock For Left Or Right Rear Seat Backrest (Through-Loading System)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Unlock rear seat backrest and fold down.
NOTE:
In event of faulty unlocking, perform emergency opening
. Refer to 52 24... Emergency Actuator For Rear Seat Backrest .
Unclip Bowden cable from holders (1).
Unfasten screws (2).
Tightening torque, see 52 26 08AZ in 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .
Pull lock (1) out of installation opening slightly and unclip Bowden cable (2).
Remove lock completely from installation opening.
Installation:
Catches (2) on lock must not be damaged.
Bowden cable must be correctly anchored in catches (2).
Installation:
Slide guide lug (1) of lock into opening (2).
Adjusting lock:
- Slacken screws
- Firmly push engaged backrest back
- Tighten down screws