51 13 316 Removing And Installing Or Replacing Trim Strip On Roof Gutter At Left Or Right
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Make sure that body is not damaged.
Open door.
Starting at front, unclip trim strip (1) in direction of arrow from clips (2).
Installation:
To avoid leaks and noises, check all clips (2) for visible damage.
If necessary, replace faulty retainers (2).
Installation:
Make sure sealing strip (1) and roof frame seal (2) are correctly seated on trim strip (3).
Sealing strip (1) and roof frame seal (2) must not be damaged.
Make sure rubber frame is installed correctly in area of side window.
IMPORTANT:
- Carry trim strip by its middle section only (risk of damage)
- Perform installation work with a second person helping
- Prepositioning of trim strip
- Ensure trim strip runs parallel to side frame (risk of breakage)