51 43 075 Removing And Installing/Replacing Side Trim Panel, Footwell, On A-Pillar, Right

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

00 9 317 TRIM PANEL WEDGE

Necessary preliminary tasks:

Remove front entrance cover strip (inside)

Detach mucket (1) in area of side trim panel (2).

Unclip side trim panel (2) with special tool 00 9 317 in direction of arrow at retaining points (3) and remove.

Fig 1: Identifying Mucket & Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bores.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Fig 2: Identifying Lever Out Clips

Courtesy of BMW OF NORTH AMERICA, INC.